Aiwa JAX-S77 사용자 설명서
T
une
r
15
GB
Manual tuning preset
You can manually tune in and store the radio
frequency of the desired stations.
frequency of the desired stations.
1
Press TUNER BAND (or FUNCTION
repeatedly) to switch the function to
tuner.
repeatedly) to switch the function to
tuner.
2
Press TUNER BAND repeatedly until
the desired band appears in the
display.
the desired band appears in the
display.
The bands you can receive vary depending
on the model you purchased.
Be sure to check which bands you can
receive.
on the model you purchased.
Be sure to check which bands you can
receive.
Every time you press the button, the band
changes cyclically as follows:
2 band model: FM
changes cyclically as follows:
2 band model: FM
y AM
3 band model: FM
t MW t SW
3
Press TUNING MODE repeatedly until
“AUTO” and “PRESET” disappear from
the display.
“AUTO” and “PRESET” disappear from
the display.
4
Press – or + (or turn TUNING operation
dial on the unit) repeatedly to tune in
the desired station.
dial on the unit) repeatedly to tune in
the desired station.
5
Press TUNER MEMORY.
A preset number appears.
6
Press – or + (or turn TUNING operation
dial on the unit) repeatedly to select the
desired preset number.
dial on the unit) repeatedly to select the
desired preset number.
7
Press ENTER.
8
Repeat steps 2 through 7 to store other
stations.
stations.
Other Operations
To change the AM tuning interval
(except for European and
Russian models)
(except for European and
Russian models)
The AM tuning interval is factory-preset to
9 kHz (or 10 kHz for some areas). To change the
AM tuning interval, tune in any AM station first,
then turn off the system. While holding
TUNING MODE on the unit, press ?/1 on the
unit. When you change the interval, all the AM
preset stations are erased. To reset the interval,
repeat the same procedure.
9 kHz (or 10 kHz for some areas). To change the
AM tuning interval, tune in any AM station first,
then turn off the system. While holding
TUNING MODE on the unit, press ?/1 on the
unit. When you change the interval, all the AM
preset stations are erased. To reset the interval,
repeat the same procedure.
Note
You cannot change the AM tuning interval in Power
Saving Mode (page 25).
Saving Mode (page 25).
Tips
• The preset stations are retained for about a day even
if you disconnect the power cord or if a power failure
occurs.
occurs.
• To improve broadcast reception, adjust the supplied
antennas, or connect a commercially available
external antenna.
external antenna.
To
Do this
Tune in a station
with a weak signal
with a weak signal
Follow the procedure described
in “Manual tuning preset”
(page 15).
in “Manual tuning preset”
(page 15).
Set another station
to the existing
preset number
to the existing
preset number
Start over from step 2. After
step 5, press – or + (or turn
TUNING operation dial on the
unit) repeatedly to select the
preset number you want to store
the other station.
step 5, press – or + (or turn
TUNING operation dial on the
unit) repeatedly to select the
preset number you want to store
the other station.