Aiwa JAX-N55 사용자 설명서

rou
b

les
hooti

Tuner

Severe hum or noise/stations cannot be
received. (“TUNED” or “STEREO” flashes in
the display.)

• Set the proper band and frequency (page 14).

• Connect the antenna properly (page 7).

• Find a place and an orientation that provide good

reception, then set up the antenna again. If you
cannot obtain good reception, we recommend you
connect a commercially available external
antenna.

• The supplied FM lead antenna receives signals

along its entire length, so make sure you extend it
fully.

• Locate the antennas as far away from the speaker

cords as possible.

• Try turning off surrounding electrical equipment.

A stereo FM program cannot be received in
stereo.

• Press FM MODE repeatedly until “STEREO”

appears.

Tape deck

The tape does not record or play, or there is a
decrease in sound level.

• The heads are dirty. Clean them (page 34).

• The record/playback heads are magnetized.

Demagnetize them (page 34).

The tape does not erase completely.

• The record/playback heads are magnetized.

Demagnetize them (page 34).

There is excessive wow or flutter, or the sound
drops out.

• The capstans or pinch rollers are dirty. Clean them

Noise increases or the high frequencies are
erased.

• The record/playback heads are magnetized.

Demagnetize them (page 34).

The tape does not record.

• No cassette is loaded. Load a cassette.

• The tab has been removed from the cassette.

Cover the broken tab with adhesive tape
(page 34).

• The tape has wound to the end.

If the system still does not
operate properly after performing
the above measures, reset the
system as follows:

Use buttons on the unit for the operation.

Disconnect the power cord.

Reconnect the power cord.

Press

, P FILE and DISC 1 at the same

time.

Press

?/1

to turn on the system.

The system is reset to the factory settings. You
should set the settings you made, such as the
preset stations, clock, and timer.