VIZIO SR-F1 사용자 설명서
Input Connector
Connection Diagrams
Installation
Input connector is used Cannon EP-4-14.
Each pin number is connected as per the following table.
Each pin number is connected as per the following table.
Pin number
1
2
3
4
S R - F 1
LOW +
LOW -
HIGH -
HIGH +
*LEFT -
RIGHT -
RIGHT +
LEFT +
Applicable plug: EP-4-11-1C
* Woofer direction viewed from the front side.
1. Single system (SR-F1)
2. Combination system (SR-F1 and SR-L1)
Mixer/Preamplifier
Electronic
control unit
Power amplifier
S R - F 1
Power amplifier
SR-F 1
S R - L 1
Electronic
control unit
Mixer/Preamplifier
Note:
Refer to "Electronic control unit's operating instructions" on the mode setting of the electronic control unit and
the level setting of power amplifier.
Secure to use power amplifier 300W (8 ) or more output.
Do not connect two speakers or more in parallel, or BTL connection of power amplifier basically.
Do not connect two speakers or more in parallel, or BTL connection of power amplifier basically.
1. Mounting the SR-F1 on the SR-L1
When one SR-F1 is mounted on the SR-L1.
When two SR-F1 are mounted on the SR-L1.
Arrange the front edges of the SR-F1
and SR-L1 as shown in the figure.
SR-F1
SR-L1
S R - F 1