Panasonic SC-HT878 사용자 설명서

RQT7429

[Note]

The front and surround speaker pairs as well as the pipe pairs are 
different.
– Check the label on the rear of the speaker before attaching the 

pipe (‹ page 8).

– The pipe with the shorter cable is for the front speaker unit.
Preparation
≥To prevent damage or scratches, lay a soft cloth and perform 

assembly on it.

≥For assembly, use a Phillips-head screwdriver.

1 Thread the speaker cable through the base.

2 Insert the pipe.

3 Secure the pipe to the 

Ensure the screw is 
securely fastened. 

≥There is no difference between the right and left speakers and stands.
≥Using the polyfoam included with this unit may be convenient.
1 Remove the screw and separate the mounting plate into 

2 Attach the plate A to the speaker.
Ensure the plate A is fastened on straight by lightly tightening the 
top and bottom screws alternately until fully tightened.

You can also attach to the upper rear of the speaker.
The height of the speaker is indicated in the diagram 
(‹ page 5) when attaching the plate A to the upper rear or 
lower rear of the speaker.

3 Place the pipe on the plate A and attach the plate B.

4 Secure the plate with the same screw removed in 

Make sure you have all the indicated components before starting the assembly, setup, and 
connection.

[HT870]

Lessen excess speaker cable.

Thread the 
speaker cable 
through here.

Insert the pipe while slightly 
pulling on the speaker cable.

Rotate the pipe so that the flat 
side is facing away from the 
back of the speaker.

Fit the offset into the slot 
and slide the plate B into 
the locked position.

7429en-p03-30.fm  4 ページ  ２００４年３月５日　金曜日　午後１１時２７分