Panasonic SC-HT822V 사용자 설명서

RQT7708

Press [TUNER] to put the remote control in TUNER mode.

Up to 15 stations can each be set in the FM and AM bands.

6] or [5] to tune to the 

Release the button when “AUTO” is displayed.

The tuner presets all the stations it can receive into the 
channels in ascending order.
≥“SET OK” is displayed when the stations are set. The last 

station to be set is then played.

6] or [5] to select the 

Press and hold [

6] or [5] until the frequency starts 

scrolling to start automatic tuning. Tuning stops when a station 
is found.

➜ above).

Alternatively, press [

W CH] or [X CH] then press [ENTER].

The station occupying a channel is erased if another station is preset 
to that channel.

Alternatively, press [

W CH] or [X CH].

To select a 2-digit number
e.g. 12: [

S10] 

➜ [1] ➜ [2].

When a stereo FM broadcast is being received.

∫ If noise is excessive in FM

Press [PLAY MODE] again to cancel the 
mode.
The mode is also canceled when you 
change the frequency.

∫ FM frequency step

Main unit only
The step is factory-set to 0.2 MHz, but you can change it to receive 
broadcasts allocated in 0.1-MHz steps.
1 Press [INPUT SELECTOR]

on the main unit to select “FM”.

2 Press and hold [INPUT SELECTOR].

After a few seconds the display changes to show the current 
minimum frequency. Continue to hold the button down. The 
minimum frequency changes and the step is changed.

To return to the original step, repeat the above steps.

[Note]

Any FM/AM frequencies preset in channels will be changed by this 
procedure. Preset them again.