Anchor Audio AN135 사용자 설명서

MADE IN USA

SIX YEAR WARRANTY

AN-135+ Speaker Monitor Owners Manual

AN-135+ TEChNICAL SPECIFICATIONS

(Specifications Subject to Change Without Notice)

Rated Power Output 

30 Watts

Max SPL @ Rated Power 

103 dB @ 1 meter

Frequency Response 

65Hz - 18KHz ±3dB

Speaker Type 

4.5” Neodymium woofer

Line Out Jack 

line level, 3.5 mm – stereo

Line In Jack 

line level, 3.5 mm – stereo & 1/4” phone – mono

AC Power Req. 

100 - 240 VAC, 47/63 Hz (70W Max.)

Dimensions 

(HWD)

 

5.25” x 8.4” x 9” (13 x 21 x 23 cm)

Weight 

3.5 lbs / 1.58 Kg

hAVING TROUBLE WITh YOUR SOUND SYSTEM?

CONDITION 

POSSIBLE SOLUTION

No Sound 

(power LED off)

 

• turn POWER switch ON

 

• charge battery or plug in AC cord

Charge Indicator LED off 

• leave plugged in for 48 hours to repair battery

No Sound 

(power LED on)

 

• check for output from source

 

• set Internal Speaker switch to ON

 

• make sure all cables are completely plugged in

 

• turn up volume control of input used

 

• remove plug from speaker output if not using external speaker 

output

Shortened Battery Life 

• charge battery fully; if battery life continues to deteriorate, 

contact Anchor Audio customer service:  (800) 262-4671

Distorted Sound 

• lower system volume control

Excessive Hum or Noise 

• use shielded cables

 

• use balanced microphone

hAVING TROUBLE WITh YOUR WIRELESS SYSTEM? (WIRELESS MODELS ONLY)

CONDITION 

POSSIBLE SOLUTION

No Sound 

(RX Indicator:  ON)

 

• set MUTE switch to on 

(handheld mic only)

 

• turn up WIRELESS volume control

 

• make sure mic is plugged into body pack transmitter

No Sound 

(RX Indicator:  OFF)

 

• push mic power button

 

• turn AN-135+ POWER switch on

 

• make sure transmitter power switch is on

 

• set receiver and transmitter to same channel

 

• replace battery in transmitter

NEED MORE HELP?  AN-135+ Speaker Monitor Setup & Operation Videos! 

Visit Our Website:  www.anchoraudio.com