Fujitsu RX100 S2 사용자 설명서

180

Chapter 7  Installing Internal Options

7.6 Installing an Internal Hard Disk 

Unit

This section explains how to install internal hard disk units. 

7.6.1 Installation Location of Internal Hard Disk Unit 

■ Order of Internal Hard Disk Unit Installation

Install the internal hard disk unit to bay 1 first, then bay 2.

• The circuit boards and soldered parts of internal options are exposed. They           

can be damaged by static electricity.

Before handling them, first touch a metal part of the server to discharge static             

electricity. 

• Do not touch the circuitry on boards or soldered parts. Hold the metallic areas             

or the edges of the circuit boards.

• Before removing the unit, turn the power off and wait for about 30 seconds until              

the disk stops completely.

• Rough handling of the hard disk unit can damage the stored data. To cope with              

any unexpected problems, always back up important data. When backing up          

data to another hard disk unit, you should make backups on a file or block              

basis.

• Use the unit in a dry place with low airborne dust levels.

• Take great care so that you do not hit the hard disk or bring it into contact with                 

metallic objects.

• Use the device on a shock-and-vibration free surface.

• Keep  the  device  away  from  direct  sunlight  and  from  radiators  or  other  heat            

sources. 

• Do not use the unit in a place where the temperature is extremely high or low,               

or experiences extreme temperature changes.

• Do not disassemble the hard disk unit.

Bay1

Bay2