Fujitsu RX100 S2 사용자 설명서

216

Chapter 8  Hardware Configuration/Utilities

8.2.16 Exit Menu

Exits BIOS Setup.

table: Items on the Exit Menu

Item

Description

Save Changes & Exit

Saves the current settings on the CMOS and exits the BIOS Setup Utility. The 
server restarts at the same time.

Get Default Values

Loads and displays the default settings for the server.

Note: 
 If you load the initial values and save the settings, the LAN settins for 

remote operation using Remote Control Service is initialized. If you load 

the initial values using this item and save them, configure the LAN setup 

including IP addresses again.

Refer to "

pg.212) on the [IPMI] submenu 

of [Server] menu.
"9.3.4 Before Using the Remote Control Service" (pg.242)

Discard Changes & Exit

Exits the BIOS Setup Utility without saving current settings. Previously saved 
settings remain valid.

Load Previous Values

Loads and displays the settings that were enabled when the BIOS Setup Utility 
started up.

Save Changes 

Save the settings on the CMOS.