Fujitsu RX100 S2 사용자 설명서

40

Chapter 2  Checking before OS Installation

2.1 Preparation on the Server

Before starting installation, install internal options to the server and perform 

necessary hardware settings. 

2.1.1 Installing Internal Options

Internal options are classified into those that must be installed before the OS installation and those that 

must be installed after the OS installation.

 

For installation procedures, refer to "Chapter 7 Installing Internal Options" (

●

Internal options that must be Installed before the OS installation

• Memory Modules

• Expansion cards

●

Internal options that must be Installed after the OS installation

• Optional SCSI devices

• Internal hard disk units where the Operating System is not installed

 If an internal option device that must be installed after the OS installation has been already installed, 

remove the device, install the OS, then reinstall the device.

■ Cautions for Installing an Expansion Card

When using an expansion card, read the notes on the expansion card. 

■ Cautions for Installing an Optional SCSI Device

When adding an optional SCSI device (DAT, etc.) using a SCSI card, connect it after installing the OS. 

Connecting it before OS installation may result in improper drive letter assignment.

■ LAN Cable

Be sure to connect the LAN cable when the server is not connected to the Internet. If the OS is installed 

or applications are automatically installed without connecting the LAN cable to the LAN card, an error 

may be recorded in the event viewer after setup completes.

 Connecting to the Internet during setup can cause security problems. Do not connect to the Internet 

until the setup completes.