Analog Devices 82-000218-01 사용자 설명서

2-6

Bluetooth EZ-Extender Manual

The TWI flash address configuration jumper (

JP1

) controls the base 

address of the configuration flash memory. When multiple EZ-Extenders 
are stacked on top of each other, it may be necessary to change the 

JP1

 set-

ting to avoid any conflict with the configuration flash memory on another 
EZ-Extender. The default is no jumper installed.

The TWI flash write protect jumper (

JP2

) is not available; the jumper is 

intended for internal Analog Devices test purposes only. The default is no 
jumper installed. 

The software reset configuration jumpers (

JP3—4

) determine which GPIO 

signal is used to perform a soft reset of the Bluegiga WT12 Bluetooth 
module. The default is no jumpers installed. 

The Bluegiga WT12 Bluetooth module default configuration jumper 
(

JP5

) resets the module’s settings to the default values. This feature 

requires software support; refer to the example programs for more infor-
mation. The default is no jumper installed. 

The UART receive data jumper (

JP6

) is not available; the jumper is 

intended for internal Analog Devices test purposes only. The default is no 
jumper installed.