Eclipse - Fujitsu Ten CD5000 사용자 설명서

Various Settings

At this time, other adjustments can also be made in normal mode.

Non-Fader phase selection (Non-F Phase)

The merging of sound between the front and rear speakers and the woofer can be improved by selecting the
phase. Switch to a phase which lets the speakers combine without any disharmony.

Turn the [SEL] button.

NORMAL: Normal phase

REVERSE: Reverse phase

Press the [SEL] button.

Crossover adjustment (X-Over)

The frequencies for the front and rear speaker high-pass filter (HPF) and woofer low-pass filter (LPF) can be
set within a range of 63 to 200 Hz. (This is the same as the HPF and LPF cutoff frequencies.)

Turn the [SEL] button to select the cut-off frequency.

63Hz

80Hz

100Hz

125Hz

160Hz

200Hz

Press the [SEL] button.

Press the buttons to set the slope.

[

] : Increases level.

[

] : Decreases level.

ATTENTION: If no woofer has been connected, set the slope adjustment to "PASS". (If slope is set to a

setting other than PASS, the low frequency range will not be output from the speakers.)

Multi-harmonizer settings (Harmonizer)

This function uses harmonic synthesis to restore the high-frequency component that is lost as a result of the
compression process so that better sound can be obtained during MP3 /WMA or Memory Stick (ATRAC3)
playback.

Turn the [SEL] button to

select the setting item.

Hi : High effectiveness
Low : Low effectiveness

… OFF

Low

OFF …

Press the [SEL] button.

Non-Fader Output

Non-Fader Output can be stereo or mono. Select the method that matches the output method for the sub-
woofer system that is connected to the main unit.

Turn the [SEL] button to select Stereo or Monaural.

Press the [SEL] button.

Press the [RTN] button.

Press the [SOUND] or [RTN] button to exit sound adjustment mode.

➔

2
3

➔

1
2