Insignia NS-HD5113 사용자 설명서
5
Insignia NS-HD5113 Car HD Radio CD Deck with USB Port
www.insigniaproducts.com
3 Install the outer trim frame on the CD deck.
4 Connect the antenna, the main wire harness
(see “Wiring your car HD radio CD deck” on
page 5), and the rear mounting bolt (if
necessary to support your CD deck). Leave the
iPod
page 5), and the rear mounting bolt (if
necessary to support your CD deck). Leave the
iPod
wire (see “Wiring your car HD radio CD
deck” on page 5) accessible.
5 Slide the car HD radio CD deck into the
mounting sleeve until it clicks into place.
6 Secure the rear mounting bolt to the firewall or
other sturdy support using the back strap (if
necessary).
necessary).
Installation method 2 - screw mount
To install the car HD radio CD deck using the
screw holes:
screw holes:
1 Remove the hooks from the sides of your CD
deck.
2 Mount the brackets to the sides of the CD deck
using two screw holes on each side.
3 Connect the antenna, the main wire harness
(see “Wiring your car HD radio CD deck” on
page 5), and the rear mounting bolt (if
necessary to support your CD deck). Leave the
iPod wire (see “Wiring your car HD radio CD
deck” on page 5) accessible.
page 5), and the rear mounting bolt (if
necessary to support your CD deck). Leave the
iPod wire (see “Wiring your car HD radio CD
deck” on page 5) accessible.
4 Fasten the brackets to the mounting location in
your car’s dashboard or console.
Wiring your car HD radio CD deck
Connect the wires to the back of the CD deck as
shown in the following illustration. You must wire
the main wiring harness prior to installing the CD
deck into the dashboard.
shown in the following illustration. You must wire
the main wiring harness prior to installing the CD
deck into the dashboard.
Removing the CD deck (DIN installation)
To remove the CD deck:
1 Remove the outer trim frame from the CD deck.
2 Insert the keys (supplied) into the sides of the
CD deck (as shown) until they click and release
the internal locks, then slide the deck out of the
mounting sleeve.
the internal locks, then slide the deck out of the
mounting sleeve.
Installing the front panel
To install the front panel:
1 Put notch A onto shaft B, then press gently into
the right side of the head unit.
Note
The outer trim frame, the hooks, and the mounting
sleeve are not used for this installation method.
sleeve are not used for this installation method.
Brackets supplied with your car
Remove the hooks from both sides of your
CD deck
CD deck
Caution
Be very careful to wire the main wiring harness
correctly. If you wire it incorrectly, or fail to properly
insulate the connections, you could damage the car
HD radio CD deck, your speakers, your car, or all of the
above.
correctly. If you wire it incorrectly, or fail to properly
insulate the connections, you could damage the car
HD radio CD deck, your speakers, your car, or all of the
above.
Shaft B
Notch A
NS-HD5113_09-0642_MAN_ENG_V3.book Page 5 Thursday, July 30, 2009 12:52 PM