Jensen Tools JCD2006 사용자 설명서

다운로드
페이지 10
JCD2006
9
SPECIFICATIONS
CD
Signal to Noise Ratio. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  > 70dB
Sampling Frequency . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  44.1Khz
Quantization Bits . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 bit
Frequency . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  5-20,000Hz
Channels . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .   2 Channel (Stereo)
FM Radio
Frequency Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .87.5-107.9MHz
Intermediate Frequency  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10.7MHz
Usable Sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . > 15dB at S/N 30dB
Stereo Separation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25dB at 1KHz
S/N Ratio. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50dB
AM/MW
Frequency Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 530-1710KHz
Intermediate Frequency  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .450KHz
Usable Sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  > 45dB
S/N Ratio. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40dB
General
Operating Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-16 VDC
Grounding System  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  Negative Ground
Speaker Impedance  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 ohms
Power Output  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  40W x 4
TROUBLESHOOTING
Symptom
Cause
Solution
No power
The vehicle’s ignition is not 
on
If the power supply is properly 
connected to the vehicle acces-
sory terminal, switch the ignition 
key to “ACC”.
The fuse is blown
Replace the fuse.
Disc cannot be loaded or 
ejected
Presence of CD disc inside 
the player
Remove the disc in the player and 
insert the new one.
Inserting the disc in reverse 
direction
Insert the compact disc with the 
label facing upward.
Compact disc is extremely 
dirty or disc is defective
Clean the disc or try to play a new 
one.
Temperature inside the 
vehicle is too high
Wait until the ambient tempera-
ture returns to normal.
Condensation
Leave the player off for an hour or 
so, then try again.
No sound
Volume is too low
Adjust volume to audible level.
Wiring is not properly con-
nected.
Check wiring connections.
The operation keys do 
not work
Control panel not properly 
installed
Reinstall control panel.
The built-in microcomputer 
is not operating properly 
due to noise
Press the RESET button.
Sound skips
The installation angle is 
more than 30 degrees.
Adjust the installation angle to 
less than 30 degrees.
The disc is dirty or defec-
tive.
Clean the disc and try to play 
again or use new disc.
Cannot tune to radio sta-
tion, auto-seek does not 
work
The antenna cable is not 
connected.
Insert the antenna cable firmly.
The signals are too weak.
Select a station manually.
ERROR 1
Mechanism Error
Press the eject button to correct 
the problem.
If the error code does not disap-
pear, consult your nearest ser-
vice dealer.
ERROR 2
Servo Error
Press the eject button to correct 
the problem.
If the error code does not disap-
pear, consult your nearest ser-
vice dealer.