Panasonic SC-HC58DB 사용자 설명서

RQT9756

As a factory preset, this unit will always turn off 
automatically if there is no sound output and no 
operation for approx. 30 minutes.
To cancel this function

Press [SETUP] repeatedly to select “AUTO OFF”.

Press [3, 4] to select “OFF” and then press [OK].

≥ To turn automatic standby on, select “ON” in step 2.

The brightness of this unit’s display can be changed.

Press [SETUP] repeatedly to select “DIMMER”.

Press [3, 4] to select “ON” and then press [OK].

≥ To cancel the dimmer, select “OFF” in step 2.

When other Panasonic equipment responds to the 
supplied remote control, change the remote control 
code.

Press [CD] to select “CD”.

While pressing and holding [SELECTOR] on the 
unit, press and hold [CD/RADIO] on the remote 
control until the unit's display shows “REMOTE 2”.

Press and hold [OK] and [CD/RADIO] on the 
remote control for at least 4 seconds.

≥ To change the mode back to “REMOTE 1”, repeat the steps 

above but replace the button pressed on the remote control 
from [CD/RADIO] to [

].

Occasionally, Panasonic may release updated 
software for this unit that may add or improve the way 
a feature operates. These updates are available free of 
charge.

Preparation
≥ Turn the unit on.
≥ Connect this unit to the wireless network. (

l 7)

– Make sure that the wireless network is connected 

to the Internet.

– If “D.CONNECT” is set to “ON”, change the setting 

to “OFF” and connect this unit to a wireless 
network that is connected to the Internet.

Press [SETUP] repeatedly to select 
“SW UPDATE” and then press [OK].

Press [3, 4] to select “UPDATE? Y” and then 
press [OK] to start the update.

When the update has finished successfully, 
“SUCCESS” is displayed.

Disconnect the AC mains lead and reconnect it 
after 3 minutes.

≥ Downloading will require several minutes. It may take 

≥ If you do not want to update the unit, select “UPDATE? N” 

and then press [OK] in step 2.

≥ If there are no updates, “NO NEED” is displayed after step 2.

∫ Checking the software version

1

Press [SETUP] repeatedly to select “SW VER.” and then 
press [OK].

{. The version of the installed software is displayed.

2

Press [OK] to exit.

≥ This setting cannot be selected when “DAB/DAB+” ([SC-HC58DB]) 

or “FM” is the source.

– “LINKING”, “UPDATING” or “%” 

(“  ” stands for a number.)

≥ During the update process, no other operations can be 

performed.

SC-HC58DBEB_DBGN_GS~RQT9756-B.book  19 ページ  ２０１３年１月２９日　火曜日　午前１０時１２分