Focal 130/165 VRS 사용자 설명서
Cables and connections
For best results with your speakers, we recommend you include the use of Focal cables.
Alternatively, other high quality cable can be used, if sufficient section thickness is available
(minimum thickness = 1mm
For best results with your speakers, we recommend you include the use of Focal cables.
Alternatively, other high quality cable can be used, if sufficient section thickness is available
(minimum thickness = 1mm
2
). This is particularly important for long lengths of cable to
ensure a strong efficient signal is maintained. Always ensure the polarity is respected, (+ is
connected to + and - is connected to -). Maintain correct connections, from principal source
radio / amplifier (left / right / front and rear), and crossover to speakers (tweeter to tweeter, mid
to mid, woofer to woofer), is always observed.
connected to + and - is connected to -). Maintain correct connections, from principal source
radio / amplifier (left / right / front and rear), and crossover to speakers (tweeter to tweeter, mid
to mid, woofer to woofer), is always observed.
Fitting the tweeter
There are two mounting possibilities available: surface or flush mount. The tweeter arrives
supplied in its flush-mounting pod. Very carefully, remove the grille, by gently prizing it off
(using a paper clip will help).
There are two mounting possibilities available: surface or flush mount. The tweeter arrives
supplied in its flush-mounting pod. Very carefully, remove the grille, by gently prizing it off
(using a paper clip will help).
Surface mounting: choose the angle that best suits your installation (10° or 30°) and mount
the pod firmly using the screws supplied. Feed the wire through the hole in the pod and refit
the tweeter and grille in place.
the pod firmly using the screws supplied. Feed the wire through the hole in the pod and refit
the tweeter and grille in place.
Flush mounting: cut a neat 45mm diameter
hole in the panel where you want to place the
tweeter. Then with the metal mounting strip held
from behind (ensuring the ends are pointing
towards the hole), insert the screw through the
flush-mount pod from the front and tighten the two
parts together. Feed the wire through the hole in
the pod and refit the tweeter and grille in place.
hole in the panel where you want to place the
tweeter. Then with the metal mounting strip held
from behind (ensuring the ends are pointing
towards the hole), insert the screw through the
flush-mount pod from the front and tighten the two
parts together. Feed the wire through the hole in
the pod and refit the tweeter and grille in place.
Grille
Unlocking tool
Tweeter
Pod
Mounting strip
130/165 VRS
U s e r
M a n u a l
3
Sortie droite
Sortie gauche
Woofer
Tweeter
Woofer
Tweeter
Input
Input
notice 130-165 vrs.indd 3
notice 130-165 vrs.indd 3
7/03/07 15:26:30
7/03/07 15:26:30