JL Audio SB-N-PTHFNDR/10W1v2/GA 사용자 설명서

Sheet SKU#011134  Revision 9/21/00

SB-N-PTHFNDR/10WØ, JL AUDIO, Inc 2000 • Page 2

STEP 6:  Remove the evaporative fuel recovery canister from
under the vehicle. To do this first remove the three 12mm bolts
holding the canister in place. Then carefully disconnect all the
hoses and wires attached to the canister. Remove the canister.

STEP 7:  Thread the supplied 

3/8

" X 1 

1/2

" bolts into the

threaded inserts in the Stealthbox. Tighten fully.

STEP 8:  Place the supplied 3" X 3" wax squares, sticky side
down, in the area of the Stealthbox mounting holes as shown.

STEP 9:  Place the Stealthbox in position. Press down on the
Stealthbox to leave a clear indent in each wax square. Remove the
Stealthbox.

STEP 10:  Check under the vehicle to be sure there are no loose
brake lines, fuel lines, etc. that may be contacted while drilling.

STEP 11:  Drill 

1/2

" diameter hole through the floor of the vehicle

in the location of the indentation in each of the wax squares.

STEP 12:  Remove the wax squares from the vehicle.

STEP 13:  Place the carpet back in its original position. Make an
"X" shaped incision in the carpet above each mounting hole.