Boss Audio Systems 765DBI 사용자 설명서

Installation using the screw holes on the sides of the unit.
Fastening the unit to the factory radio mounting bracket.

1.  Select a position where the screw 

holes of the bracket and the screw 
holes of the main unit become 
aligned (are fitted) and tighten the 
screws at 2 places on each side.

2.   Screw
3. Factory radio mounting bracket.
4. Dashboard or Console
5. Hook (Remove this part)

Note: the mounting box, outer trim ring,
and half-sleeve are not used for method 
B installation.

5

2

4

3

2

5

a.  Frame
b.  Insert fingers into the groove in the 

front of frame and pull out to remove 
the frame. (When re-attaching the 
frame, point the side with a groove 
down wards and attach it.)

c. Insert the levers supplied with the 

unit into the grooves at both sides of 
the unit as shown in figure until they 
click. Pulling the levers makes it 
possible to remove the unit from the 
dashboard.

Push the trim plate against the chassis until it is fitted. 
You must do this before you install the front panel, otherwise it can't be attached.

a

b

c

3