Panasonic A66HY 사용자 설명서

Before finally installing the unit, connect the wiring temporarily and make sure it is all 
connected up properly and the unit and system work properly.
Use only the parts included with the unit to ensure proper installation. The use of 
unauthorized parts can cause malfunctions.
Consult with your nearest dealer if installation requires the drilling of holes or other 
modifications of the vehicle.
Install the unit where it does not get in the driver's way and cannot injure the passenger if 
there is a sudden stop, like an emergency stop.I
If installation angle exceeds 30° from horizontal, the unit might not give its optimum 
performance.

Avoid installing the unit where it would be subject  to high temperature, such as from direct 
sunlight, or from hot air, from heater, or where it would be subject to dust dirt or excessive 
vibration.
Be sure to remove the front panel before installing  the unit.

This unit can be property installed either from “Front” (conventional DIN Front-mount) or 
“Rear”(DIN Rear-mount installation, utilizing threaded screw holes at the sides of the unit 
chassis). For details, refer to the following illustrated installation methods A and B.
DIN FRONT-MOUNT (Method A)

1. Dashboard

2. Holder

 After inserting the half sleeve into the dashboard, 

select the appropriate tab according to the 
thickness of the dashboard material and bend 
them inwards to secure the holder in place.

3. Screw

30°

1

7

4

2

3

5

6

1.  Dashboard      
2.  Nut (5mm)     
3.  Spring washer
4.  Screw (5x15mm)  
5.  Screw        
6.  Support Strap
     Be sure to use the support strap to secure the 

back of the unit in place. The strap can be bent by 
hand to the desired angle.

7.  Plain washer

1

2

3

a.  Frame
b.  Insert fingers into the groove in the front of frame 

and pull out to remove the frame. (When re-
attaching the frame, point the side with a groove 
down wards and attach it.)

c.  Insert the levers supplied with the unit into the 

grooves at both sides of the unit as shown in 

figure until they click. Pulling the levers makes it 

possible to remove the unit from the dashboard.

a

b

c

Trim Plate Installation:
Push the trim plate against the chassis until it is fitted. 
You must do this before you install the front panel, otherwise it can't be attached.

E - 3