Sony 3-869-888-16 (1) 사용자 설명서
10
Chapter 1 Introduction
A Power LED
Alternates between green and amber lights when the unit is starting up.
Lights green when startup is complete.
Lights amber when it is on standby.
Alternates between green and amber lights when the unit is starting up.
Lights green when startup is complete.
Lights amber when it is on standby.
B Network LED
Lights green when there is activity at the corresponding LAN connector at the
rear of the NSR.
Lights green when there is activity at the corresponding LAN connector at the
rear of the NSR.
C HDD LED
Blinks green when the internal hard disks are accessed.
Lights amber when an error occurs with a hard disk.
Blinks green when the internal hard disks are accessed.
Lights amber when an error occurs with a hard disk.
D Status LED (1 to 4)
Lights in sequence (1, 2, 3, 4) when the NSR starts.
When an error occurs, the corresponding status LED lights together with the
error LED, which lights or blinks to indicate the type of error.
Lights in sequence (1, 2, 3, 4) when the NSR starts.
When an error occurs, the corresponding status LED lights together with the
error LED, which lights or blinks to indicate the type of error.
For details, see “STATUS LED” (page 168).
E Error LED
Lights or blinks when an error occurs.
Lights or blinks when an error occurs.
F REC LED
Lights when recording images.
Lights when recording images.
G Combo drive
Use this drive to write data from the NSR hard disks to CD.
Use this drive to write data from the NSR hard disks to CD.
H Lock
Use this in conjunction with the supplied front panel key to lock the front bezel.
When the front bezel is locked, you cannot pull out the front bezel. Also, do not
lock the front bezel when the front bezel is pulled out. You can distinguish the
locked position from the unlocked position by looking at the lock, as illustrated
below.
Use this in conjunction with the supplied front panel key to lock the front bezel.
When the front bezel is locked, you cannot pull out the front bezel. Also, do not
lock the front bezel when the front bezel is pulled out. You can distinguish the
locked position from the unlocked position by looking at the lock, as illustrated
below.
I Vent holes
These openings allow air to flow from the front of the NSR to the rear.
Do not block the vent holes, allow dust to accumulate in the inner mesh of the
vent holes, or obstruct the airflow in any way. Obstructing the airflow allows
heat to build up inside the NSR and may result in fire or damage.
These openings allow air to flow from the front of the NSR to the rear.
Do not block the vent holes, allow dust to accumulate in the inner mesh of the
vent holes, or obstruct the airflow in any way. Obstructing the airflow allows
heat to build up inside the NSR and may result in fire or damage.
The front bezel is
locked
locked
The front bezel is
unlocked
unlocked