JAI TS-2030EN 사용자 설명서

 
 

 

 

 

 

As a guideline the two LEDs marked TRIG-0 and TRIG-1 shall be off when no trigger pulse is present. 

Activating switches S1 and S4 generates a trigger pulse for test purposes. Only one trigger pulse is 

generated each time the switch is activated. 

The duration of the trigger pulse is approximately 4 ms. 

The trigger indicator LEDs flash when the test trigger switch is activated. 

 

The Lane Controller connection to the J-Panel is connector X15. The connections are listed in Table 
8 . 

1 

D0+ 

RS485 databus D0+ 

Lane Controller databus 0+ 

2 

D0- 

RS485 databus D0- 

Lane Controller databus 0- 

3 Gnd gnd 

gnd 

4 

D1+ 

RS485 databus D1+ 

Lane Controller databus 1+ 

5 

D1- 

RS485 databus D1- 

Lane Controller databus 1- 

 

It is possible to have one Lane Controller connected to several cameras or one Lane Controller to 

each camera: 

One Lane Controller for two or more cameras 

1. The Lane Controller is connected to the X15 pin 1 and 2 (no connections to pin 4 and 5) 

2. Switch S2 position “OPEN” 

3. The Lane Controller can be connected to more J-Panels by connecting RJ45 patch cables between 

connector X4 and connector X5 on the next J-Panel (and from X4 on the next J-Panel to X5 on the 
third J-Panel). Switch S2 on the other J-Panels must also be in the “OPEN” position. 

Two Lane Controller to two cameras 

1. The Lane Controller for camera 0 is connected to X15 pin 1 and 2 

2. The Lane Controller for camera 1 is connected to X15 pin 4 and 5 

3. Switch S2 position “TERM” 

4. Do not connect any cables to X4 and X5