JAI TS-2030EN 사용자 설명서
Appendix A: Camera Functional & Connector Description
55
VIS-CAM System
5.3.9 (a) Connector physical Interface
Table 15
Physical interface pinouts.
Pin Signal Description
Connection
to
1 Gnd Light/Flash
Gnd
Light/Flash
ground (negative power terminal)
2
Out
Light control/Strobe out
Light control input or strobe input on flash unit
3 Stat Light/Strobe
status
Light/Flash Status output from unit
4
FPWR
Light/Flash power
Power from Light/Flash unit to output circuit on I/O Board
The Gnd signal on pin 1 is connected to the Gnd signal on X5 (pin 2) internally on the board.
5.3.10 Typical Wiring Diagram
Figure 52 shows how to connect to the 2nd DC Flash unit having the I/O Board electronics powered
from the Flash Power Supply.
Figure 52. Wiring a second DC flash from the flash power supply.