JAI TS-1327EN 사용자 설명서

 

 

 

 

 

19 

1.  Attach the pipe clamps approximately 6-inches apart on a vertical mounting surface as 

shown in Figure 13. 

2.  Loosen the four Allen screws and remove the flange from the mounting base. Figure 10, 

“Install the traffic light sensor.,” on page 15. 

3.  Route the Traffic Light Sensor end of the TLS-300 signal and  

the power cable through the pipe and flange. 

4.  Screw the flange onto the pipe somewhat tightly to allow  

subsequent minor adjustment 

5.  Place the pipe in the pipe clamps and tighten them to secure  

the pipe to the vertical mounting surface. 

6.  Attach the Traffic Light Sensor body to the flange and secure  

it with the four Allen screws. 

7.  Orient the Traffic Light Sensor such that the white reflectors  

are parallel to the trigger plane with side B facing (visible  
from) the trigger plane 

8.  Route the free end of the cable to the VIS J-Panel in  

accordance with local code requirements 

9.  Connect the color-coded wires to the J-Panel connector X3 as  

described in Section 3.3 on page 21. Make sure that no power  

is applied when performing any wiring operation. 

In general, the camera(s) should be aimed at the most likely cross-lane position of the vehicle 
license plates. See “Installation Preparation” on page 6 for general site layout guidelines. To install 

the camera(s): 

1.  Attach the camera mount to the camera enclosure using the included mounting bolts and washers. 

Refer to Figure 14.