JAI TS-1327EN 사용자 설명서

 

 

 

 

 

43 

•  Press the “Repetitive Trigger” button on the ENSetup toolbar. This will trigger the camera every 

second. Make sure that the “Ethernet” external hardware trigger is enabled in the “Camera 

Properties” section “2 – Trigger”, property “External Trigger Source”. 

 

•  Adjust the flash head tilt and pan control until the entire back of the vehicle is well illuminated. 

If necessary, adjust the flash-head pan control to center the flash beam over the vehicle. 

•  If the flash illumination is too bright for your installation, contact JAI for instructions on how to 

adapt VIS system parameters to reduce sensitivity to nighttime illumination. 

Repeat pressing the “Repetitive Trigger” button on the ENSetup toolbar to stop flash firing. Repeat 

the above steps for each camera/flash.  

3.5 TBD  2 

1 

TBD 

TBD 

TBD TBD 

 
Distance measured from outer wall of Camera housing to outer wall of Flash unit.