JAI CV-M91 사용자 설명서

 

- 17 - 

 

Refer to “7. Configuring the Camera.” 

 

Scanning:  SW1-5 on rear selects interlaced or non-interlaced. Non-interlaced PAL = 312H in 

EVEN field. Non-interlaced NTSC = 262 H in ODD field. 

 

Gamma: 

SW1-6 on rear for gamma select. Gamma = 1 or gamma =0.45. 

 

Gain: 

SW1-7 on rear select manual gain or AGC. Manual gain is set by VR7 on PK8406. In 

AGC the gain is automatic. The AGC level is set by potentiometer VR3. 

 

Control: 

SW1-8 on rear selects the camera control mode. Either local by switches, or remote 

by “Camera Control Tool” via RS-232C. (Should be in position before power on.) 

 

 

Jumper JP305 and JP306 on PK8407 are for switching between VD in/VD out. 

 

Jumper JP308 and JP309 on PK8407 are for switching between HD in/HD out 

 

 

SW301 on PK8407 can terminate signal inputs from TTL to 75 Ω.  

 

SW301-1 for HD. SW301-2 for VD. SW301-3 for ext. trigger. (On for 75Ω.)  

 

Jumper JP312, JP313, JP315, JP318 and JP319 on PK8407 select ext. HD/VD in or 

composite signal to the sync separator, which separate HV/VD. 

 

Sync/WEN:  Jumper JP303 and JP304 on PK8407 for Sync or WEN out on pin #7 on 9 pin sub-D. 

 

 

SW604 on PK8404 to ON for composite sync signal on green video output. 

 

 

Jumper JP301 on PK8407 short for pixel clock out on pin #9 on 12-pin connector. 

 

Frame/field accumulation: 

 

SW301-4 on PK8407 for frame or field accumulation. 

 

CCD iris: 

SW201 on PK8408 to ON for CCD iris function in the regulation. The reference level 

can be set by potentiometer VR10 on PK8406. 

 

SW202 on PK8408 switch between manual and one push white balance. Manual 

allows the white balance to be set by R and B potentiometer on rear. One push is 

done automatic if switch on camera rear is pressed. 

 

 

R and B gain potentiometer on camera rear is for manual white adjust. 

 

VR7 on PK8406 is for manual gain setting. *) 

CCD iris setting: 

 

VR10 potentiometer on PK8406 is for CCD iris reference level. *) 

 

 

VR3 potentiometer on PK8406 is for AGC reference level. *) 

 

The following functions are for RS 232C control only. 

 

Red, Green and Blue gain level. *) 

 

Red, Green and Blue white clip level. *) 

 

Red, Green and Blue offset level. *)