Q-See QSDR 사용자 설명서

Click on Begin.
If you receive a message stating that the port is online and can be reached, then you have set 
it up correctly.

To connect to your DVR from the Internet, you will need to put the Internet IP address shown 
after “Your Internet Address:” message into the browser or access program window.

If you are forwarding any other port instead of port 80, then you need to put that port’s num-
ber at the end of the address.

Example: if you use port 85, you will need to enter: http://75.14.251.43:85

Instructions for using the ASee software on your smartphone can be found on the CD that 
came with your DVR, or it can be downloaded by clicking on the links below:
Android: 

Blackberry: 

iPhone: 

Symbian: 

Windows Mobile: 

NOTE!  You  will  only  need  to  proceed  with  this  section  if  you  detected  a 
second router in Section 2.

NOTE!  If you do not have a DMZ setting in the router, check to see if there 
is a 

Bridge setting. If so, then use the Bridge setting instead of DMZ.

STEP 1. Login into Router 1 by putting 

the IP of Router 1 into the Internet 
Explorer browser, as in the example 
shown in 

Picture 21

 where the IP 

address of Router 1 is 192.168.0.1

STEP 2. Find the status page on the 

router settings that shows the WAN/
Internet IP address and  write it down 
this WAN IP address.

STEP 3. Log into the Router 2 by putting 

the IP of Router 2 into the Internet 
Explorer browser, as in example 
shown in 

Picture 21

 where the IP 

address of Router 2 is  192.168.1.1

STEP 4. Find the DMZ page in the router 

settings.

STEP 5. Enter the WAN IP for Router 1 

into the 

DMZ page and enable DMZ.

STEP 6. Save your changes.

You have forwarded the ports on the router to which the DVR is connected, to the IP address 
of the DVR, and set the primary router to pass the connection to this router.