VIVOTEK IP8372 사용자 설명서

 

 

On this page, you can tune the White balance, Image adjustment and WDR enhanced .

White balance: Adjust the value for the best color temperature.

■ Auto: Firmware will automatically adjust the color temperature in the current lighting condition in 

response to different light sources. 

   You may follow the steps below to adjust the white balance to the best color temperature.

1. Set the White balance to 

Auto.

2. Place a sheet of white paper or a cooler-color (such as blue) in front of the lens, then allow the 

Network Camera to automatically adjust the color temperature.

3. Check 

Fix current value to confirm the setting while the white balance is being measured.

■ Manual: This item allows user to input the R gain & B gain manually.

Image Adjustment

■ Brightness: Adjust the image brightness level, which ranges from -5 to +5.

■ Contrast: Adjust the image contrast level, which ranges from -5 to +5. Please note that this 

function will be disabled if you enable WRD enhancement in the column below.

■ Saturation: Adjust the image saturation level, which ranges from -5 to +5. You can also select 

Customize and manually enter a value.

■ Sharpness: Adjust the image sharpness level, which ranges from -3 to +3. You can also select 

Customize and manually enter a value.

■ Gamma curve: Adjust the image sharpness level, which ranges from 0% to 100%. 

  You may let firmware 

Optimize your display or select the Manual mode, and pull the slide bar 

pointer to change the preferred level of Gamma correction towards higher contrast or towards the 

Sensor Setting 2: 

For special situations

Sensor Setting 1:

For normal situations