VIVOTEK IP8161 사용자 설명서

 

 

 

 

The reset button is used to reset the system or restore the factory default settings� Sometimes 

resetting the system can return the camera to normal operation� If the system problems remain 

after reset, restore the factory settings and install again�

Reset: Press and release the recessed reset button with a paper clip or thin object� Wait for the 

Network Camera to reboot�

Restore: Press and hold the recessed reset button until the status LED rapidly blinks� It takes 

about 30 seconds� Note that all settings will be restored to factory default� Upon successful 

restore, the status LED will blink green and red during normal operation�

This network camera is compliant with 

SD/SDHC 16GB / 8GB and other preceding standard SD 

cards�

Follow the steps below to 

mount the lens to the Network Camera

:

1� Mount the lens by turning it clockwise onto the camera mount until it stops� If necessary, turn 
    the lens counterclockwise slowly until it gets the best attitude�
2� Connect the lens cable plug to the camera connector�

     

Recessed Reset 

Button

Status LED