VIVOTEK 4X-IP7142 사용자 설명서

VIVOTEK - A Leading Provider of Multimedia Communication Solutions

8 - User's Manual

Network deployment

Setup the Network Camera over the Internet

This section explains how to conﬁgure the Network Camera to Internet connection.

1. If you have external devices such as sensors and alarms, make connection from general I/O

terminal block.

2. Use the supplied RJ45 female/female coupler to connect the Network Camera to a switch.

Use Catagory 5 Cross Cable when Network Camera is directly connected to PC.

3. Connect the power cable from the Network Camera to a power outlet.

There are several ways to setup the Network Camera over the Internet. The ﬁrst way is to setup
the Network Camera behind a router. The second way is to utilize a static IP. The third way is to
use PPPoE.

Internet connection via a router

Before setting up the Network Camera over the Internet, make sure you have a router and follow
the steps below.

1. Connect your Network Camera behind a router, the Internet environment is illustrated as
below. About how to get your IP address, please refer to Software installation on page 10 for
details.

IP address : 192.168.0.3
Subnet mask : 255.255.255.0
Default router : 192.168.0.1

IP address : 192.168.0.2
Subnet mask : 255.255.255.0
Default router : 192.168.0.1

LAN (Local Area Network)
Router IP address : 192.168.0.1

WAN (Wide Area Network )
Router IP address : from ISP

Cable or DSL Modem

LAN (Local Area Ne
Router IP address :

WAN (Wide Area Network )
Router IP address : from ISPP

POWER

COLLISION

LINK

RECEIVE

PARTITION

Internet

N.C.: No Connector
485B: RS485-
485A: RS485+
AC24V: Power in AC 24V
AC24V: Power in AC 24V

GND: Ground
DI : Digital Input
DO : Digital Output
+12V : Power, 12V DC

GND
DI
DO
+12V

POWER

COLLISION

LINK

RECEIVE

PARTITION

Ethernet switch