JVC VN-686WPBU 사용자 설명서

다운로드
페이지 130
26
Connection/Installation (VN-V686WPBU)
Setting Up the Wall
Make holes in the wall
Make holes (
R 45 mm) for the connecting cables 
to pass through.
Note: 
                                                              
● Check the strength of the wall. A less firm 
wall may cause the unit to fall.
Install the anchor bolts for mounting 
the camera
Install 4 anchor bolts (M8 
⳯ 35 mm and above) 
to mount the camera.
Install the anchor bolt for mounting 
the fall prevention wire
Install the anchor bolt (M8 
⳯ 35 mm and above) 
to mount the fall prevention wire 30 mm below 
the center of the upper two anchor bolts that are 
used to mount the camera.
Pull the cables from the hole in the 
wall
Pull the power cable, LAN cable and alarm 
signal cable from the wall.
Setting Up the Camera
Remove the dome cover
Loosen the screws (x4) and remove the dome 
cover from the camera.
Remove the cushioning material, lens 
cap and tape used during 
transporting
When installing the heater at an unrequired 
location, turn off the switch of the heater.
Mounting the Camera
Be sure to put on protective glasses to protect 
your eyes from falling objects when mounting 
the camera.
213
176
60
20
152
126
63
45
12
30
1
2
3
Anchor bolts to 
mount the camera
Anchor bolt to 
mount the fall 
prevention wire
Alarm signal cable
Power cable
LAN Cable
Dome Cover
OFF
Cushioning material
Lens cap
Tape
Heater power 
switch