VIVOTEK IP3136 사용자 설명서

 

 

 
 

 
 
 

 

  

www.vivotek.com 

 

 

 

 
 

“Sun” ~ “Sat” Select the days of the week to perform the following operations. 
“Snapshots begin at” Set the time to start operations.   
“Snapshots stop at” Set the time to stop operations. 
Setting identical begin time and stop time means 24-hour operation. 
“All the time except for the above schedule” Set the schedule all the time except 
for the above in a week. 

“Delay second(s) before detecting next motion” Set the time delay before 
restarting to check on the triggering condition when the current condition is triggered. 
“Take snapshots at second(s) after motion” After the camera has taken a 
snapshot when a condition is triggered, another snapshot will be taken after this 
configured interval, in seconds. 
“Trigger condition” There are three windows for motion detection each can be 
assigned a name. If motion detection has not been set up, “undefined” will be shown 
instead of the window title. If this happens, clicking on “Motion detection” and a note 
will show to direct the User to the configuration page for motion detection. 

“Snapshot every second(s)” The Network Camera will send snapshots at the 
specified intervals to the external server using the method selected below. Remember: 
This operation is still subject to the conditions set in the weekly schedule. 
“Send snapshots by email” This selects the uploading method following the 
intervals set above. The snapshot named “video.jpg” will be attached in the email with 
the subject title “Periodic snapshots”.