Speco Technologies M215LCBV4 사용자 설명서

 

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant 

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 

interference in a residential installation. 

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in 

accordance with the instructions, may cause harmful interference to radio communications. However, 

there is no guarantee that interference will not occur in a particular installation. 

If this equipment causes harmful interference to radio or television reception, which can be determined by 

turning the equipment off and on, the user is encouraged to try to correct the interference by one or more 

of the following measures. 

- Reorient or relocate the receiving antenna. 

- Increase the space between the equipment and receiver. 

- Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected. 

- Consult the dealer, an experienced radio, or a TV technician for help. 

- Only a shielded interface cable should be used. 

Finally, any changes or modifications to the equipment by the user not expressly approved by the grantee 

or manufacturer could void the user's authority to operate such equipment. 

 

▶  DOC COMPLIANCE NOTICE 

This digital apparatus does not exceed the Class A limit for radio noise emissions from digital apparatus 

set out in the radio interference regulation of Canadian Department of    Communications. 

 

This monitor complies with the basic protection requirements of the Electromagnetic Compatibility (EMC) 

Directive 2004/108/EC for electrical and electronic equipment imported into the European Union (EU): 

The electromagnetic disturbance generated by the apparatus does not exceed the level specified in the 

harmonized EMC Standards for this type of apparatus. It has a level of immunity to the electromagnetic 

disturbance to be expected in its intended use, and should operate without unacceptable degradation of 

its specified performance.