Barco MDNC 4130 사용자 설명서
Configuring Windows
64
rectangle for the virtual display representing the two heads
controlled by each BarcoMed display controller output.
controlled by each BarcoMed display controller output.
If you installed your B
ARCO
N
IO
F
USION
Display System drivers in
DualView mode (default for Windows XP) there will be a
rectangle representing each head controlled by each output of
the display controller. This will be true even if you have only one
display connected to your B
rectangle representing each head controlled by each output of
the display controller. This will be true even if you have only one
display connected to your B
ARCO
MXRT controller. Both displays of
a display controller cannot be enabled at the same time unless
their display properties match. If necessary detach the second
display of the B
their display properties match. If necessary detach the second
display of the B
ARCO
MXRT display controller you are working
with by right clicking on the rectangle that represents it,
deselect Attached and click the Apply button.
deselect Attached and click the Apply button.
Note: Since Windows will not let you detach the primary
display connected to a particular controller, you may need to
temporarily make another display the primary display
display connected to a particular controller, you may need to
temporarily make another display the primary display
4.
For the display which is still attached click Click on the Advanced
Button.
Button.
5.
Select the Adapter tab and then click on the List All Modes
button. Select the resolution and refresh rate that your B
button. Select the resolution and refresh rate that your B
ARCO
N
IO
F
USION
Display display supports from the dialog box and click OK.
Note: In the Adapter box, the Adapter string shows if this
display is the First View or the Second View attached to the
display controller. Please make a note of this, so that you can
arrange the displays in the correct order later if necessary.
display is the First View or the Second View attached to the
display controller. Please make a note of this, so that you can
arrange the displays in the correct order later if necessary.
6.
Click OK on the bottom of the Adapter Control Panel. If the “OK”
button on the bottom of the Adapter Control Panel is not visible,
press the TAB key once and then press CTRL+Enter to select OK.
button on the bottom of the Adapter Control Panel is not visible,
press the TAB key once and then press CTRL+Enter to select OK.
7.
Click OK in the “Windows will now apply your new desktop
settings” dialog box. Your B
settings” dialog box. Your B
ARCO
N
IO
F
USION
Display display should
now synchronize and display the Windows desktop.
8.
Click Yes when asked, “Your desktop has been reconfigured. Do
you want to keep these settings?”
you want to keep these settings?”