Jonsered CS 2141 EPA II 사용자 설명서

English

 – 35

Following is a list of recommended cutting equipment for the Jonsered chain saw models 2141, 2145 and 2150. The combinations 
of power head, bar and chain have been investigated in accordance with the kickback and vibration requirements of ANSI B 175.1–
2000.

The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the corresponding 
maximum nose radius of a solid bar.

The following list is the chain saw manufacturers recommendations. There may be other combinations available, which will also 
achieve kickback reduction.

As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For guide 
bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth may be 
considered to have equivalent kickback energy. A hard nose bar having the same length and nose radius as a sprocket-nose bar 
may be considered to have equivalent or less kickback energy than the sprocket-nose bar.

Low kickback saw chain is a chain which has only met the kickback performance requirements of ANSI B 175.1 safety requirements 
for gasoline powered chain saws when tested on the representative sample of chain saws below 3.8 cu. in. specified in ANSI 175.1. 
We recommend that you as a replacement use the listed chains or "Low kickback saw chains" which are available at your dealer.

Note: For the chains above you are free to choose between 0,050", 0,058" and 0,063" gauge drive link for the corresponding bar, 
see the table below.

13

0,325

10T

Jonsered S30, Oregon 95VP

15

0,325

10T

16

0,325

10T

18

0,325

10T

13

0,325

10T

Jonsered S25, Oregon 21BP

15

0,325

10T

16

0,325

10T

18

0,325

10T

S30/95VP

20BP

-

S25/21BP

-

22BP

L