Zenoah EXZ2610DL 사용자 설명서

GB-13

EXZ2610DL

(1) Main pipe
(2) Trimming mechanism
(3) Screw hole
(4) Screw
(5) Fastening bolt

1. Remove the screw screwed into the end of the trim-

ming mechanism.

2. Insert the end of the trimming mechanism into the

main pipe.

3. Line up the hole on the end of the trimming mecha-

nism into which the screw is to be inserted with the
hole on the main pipe, and screw the screw firmly in.

4. Using a wrench, screw in the bolt provided to fix the

trimming mechanism into place.

BALANCE UNIT
1. Put on strap and attach unit to strap.
2. Depending on the working posture, slide clamp up

or down until unit balances and the strap fits your
body.

(1) Main pipe

(2) Transmission

(3) Screw hole

(4) Fastening bolt

(5) Bolt

1. Remove the cap on the end of the main pipe.
2. Remove the screw screwed into the end of the trans-

mission.

3. Insert the end of the gear case into the main pipe.
4. Line up the hole on the end of the transmission into

which the screw is to be inserted with the hole on the
main pipe, and screw the screw firmly in.

5. Using a wrench, screw in the bolt provided to fix the

mechanism into place.

1. Loosen a nut and remove the chain cover.
2. Mount the guide bar then fit the saw chain around the

bar and sprocket.

A standard package contains the items as shown below.

(1) Guide bar

(2) Saw chain

(3) Transmission

(4) Sprocket

(5) Chain tension adjust screw (6) Nut
(7) Chain tensioner nut

(8) Chain cover

Install the guide bar and the saw chain on the transmis-
sion as follows.

3. Fit the chain tensioner nut into the lower hole of the

guide bar, then install the chain cover, and fasten the
mounting nut to finger tightness.

(1) Hole
(2) Moving direction
(3) Chain tensioner nut