Agri-Fab 2468 사용자 설명서

15

11. After cart is emptied, secure cart to tongue with latch 

and reattach the rear door and the vinyl boot.

1.  Your Chip-N-Vac engine is shipped without oil or 

gasoline. Service the Chip-N-Vac engine with oil and 
gas as instructed in the separate engine manual.

2.  Inspect the Chip-N-Vac to make sure all covers (rear 

door, vinyl boot, elbow, hose adapter, hose and deck 
adapter are properly attached.

3.  Check tires for proper inflation (12 - 14 lbs).

fill fuel tank indoors, or

with the engine running, or while the engine 

is hot. Do not smoke while filling tank.

1.  To stop engine, move the throttle control lever to the 

OFF position.

2.  Disconnect spark plug wire from plug to prevent ac-

cidental starting while equipment  is unattended or is 
being worked on.

The muffler and adjacent

areas are 

1.   Check oil and gas in Chip-N-Vac engine.
2.  Attach spark plug wire to spark plug.
3.  Move choke lever on engine to CHOKE position. 
 

(A warm engine may not require choking.)

4.  Move throttle control lever on engine to FAST position.
5.  Grasp starter handle and pull rope out slowly until 

engine reaches start of compression cycle (rope will 
pull slightly harder at this point). Let the rope rewind 
slowly.

6.  Pull rope with a rapid, continuous, full arm stroke. 

Keep a firm grip on starter handle. Let rope rewind

slowly. Do not let starter handle snap back against 
starter.

7.  Repeat instructions in two preceding paragraphs until 

engine fires. When engine starts, move choke control

gradually to RUN position.

  Never start or run the 

engine without all covers being properly 
attached to the blower housing and cart.

    Vehicle braking and stability 

may be affected with the addition of an 
accessory or an attachment. Be aware of 
changing conditions on slopes.

1.  Inspect the Chip-N-Vac to make sure all covers (rear 

door, vinyl boot, elbow, chipper chute with tamper 

plug, hose adapter (nozzle), hose and deck adapter

are properly attached.

2.  Check tires for proper inflation (12 - 14 lbs).

3.   Check oil and gas in Chip-N-Vac engine.
4.  Begin operation at low speed, adjusting forward speed 

to match grass height and/or moisture condition to 
prevent clogging.

5.  Do not attempt to vacuum up any material other 

than vegetation found in a normal yard, such as light 
branches, leaves, twigs, etc.

6.  To empty cart, shut off tractor engine and set brake. 
7.  Shut off Chip-N-Vac engine.
8.  Remove rear door from cart.
9.  Release the latch holding cart down to the tongue by 

pulling up on the latch lever. See figure 28.

10. Using a rake or suitable tool, pull the grass clippings 

and/or leaves out of cart.

  Should your Chip-N-Vac 

become clogged, shut off tractor and 
Chip-N-Vac engines. Before attempting 
to unclog, remove wire from spark plug to 
prevent accidental starting.

  To avoid possible injury, be 

sure that no one is near the cart before 
releasing the latch.