Tanaka TBL-505 사용자 설명서

 
 

 
www.tanakapowerequipment.com                          6                                               custsvc@tanaka-ism.com

 

 

 
 

 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

3. Pull recoil starter briskly, taking care to keep the handle in your grasp 

and not allowing it to snap back. (Fig. 2-5, 5B) 

4. When you hear the engine want to start, return choke lever to RUN 

position (open). Then pull recoil starter briskly again. 

CAUTION! 
Do not start if the pipe is obstructed by the ground or any other object. 

1 .Set ignition switch (1) to ON position. 
  (Fig. 2-2, 2B, 2C) 

•  Push priming bulb (4) several times so that fuel flows through return pipe (5) (if so equipped) (Fig. 2-3, 3B) 

•  Move throttle lever to a half-open position (2) and lock it with lock lever (4) (if so equipped), when it is hard to 

start engine. (Fig. 2-2C)

 

2. Set choke lever to CLOSED position (4). Fig. 2-4, 4B 

If engine does not start, repeat procedures from 2 to 4. 

5. After starting engine, allow the engine about 2-3 minutes to warm up 

before subjecting it to any load. 

Note! (TBL-4610) 
Model TBL-4610 does not have an ignition switch. 
To start or to stop the unit, ignore the switch operation from procedures in the manual.  However, when 

starting the unit, move throttle lever to START position.