Troy-Bilt 204 사용자 설명서
12
For repairs beyond
the minor adjustments
listed here, contact
an authorized service
dealer.
6
Trouble
Shooting
Cause
Problem
Remedy
Engine fails to start
1. Throttle lever not in correct starting
position.
2. Spark plug wire disconnected.
3. Choke not in CHOKE position (if
3. Choke not in CHOKE position (if
equipped).
4. Fuel tank empty or stale fuel.
5. Engine not primed (if equipped).
5. Engine not primed (if equipped).
6. Faulty spark plug.
7. Engine flooded.
7. Engine flooded.
1. Move throttle lever to FAST or
START position.
2. Connect wire to spark plug.
3. Move choke lever to CHOKE
3. Move choke lever to CHOKE
position.
4. Fill tank with clean, fresh gasoline.
5. Prime engine as instructed in
5. Prime engine as instructed in
Engine Manual.
6. Clean, adjust gap, or replace.
7. Wait a few minutes to restart, but
7. Wait a few minutes to restart, but
do not prime.
Engine runs erratic
1. Connect and tighten spark
plug wire.
2. Move choke lever to OFF position.
3. Clean fuel line; fill tank with clean,
3. Clean fuel line; fill tank with clean,
fresh gasoline.
4. Always run engine at full throttle.
5. Drain fuel tank. Refill with
5. Drain fuel tank. Refill with
fresh fuel.
6. Refer to engine manual.
7. See authorized service dealer.
7. See authorized service dealer.
1. Spark plug wire loose.
2. Unit running on CHOKE (if equipped).
3. Blocked fuel line or stale fuel.
3. Blocked fuel line or stale fuel.
4. Low engine RPM.
5. Water or dirt in fuel system.
5. Water or dirt in fuel system.
6. Dirty air cleaner.
7. Carburetor out of adjustment.
7. Carburetor out of adjustment.
Engine overheats
1. Fill crankcase with proper oil.
2. Refer to engine manual.
3. See authorized service dealer.
2. Refer to engine manual.
3. See authorized service dealer.
1. Engine oil level low.
2. Dirty air cleaner.
3. Carburetor not adjusted properly.
2. Dirty air cleaner.
3. Carburetor not adjusted properly.
Occasional skips
(hesitates) at
high speed
1. Remove spark plug and adjust gap.
2. See authorized service dealer.
2. See authorized service dealer.
1. Spark plug gap too close.
2. Carburetor idle mixture adjustment
2. Carburetor idle mixture adjustment
improperly set.
Unit does not
discharge
1. Stop engine immediately and
disconnect spark plug wire. Clean
flail screen and inside of discharge
opening.
flail screen and inside of discharge
opening.
2. Stop engine and disconnect spark
plug wire. Remove lodged object.
3. Always run engine at full throttle.
4. Empty bag.
4. Empty bag.
1. Discharge area clogged.
2. Foreign object lodged in impeller.
3. Low engine RPM.
4. Vacuum bag is full.
4. Vacuum bag is full.
Rate of discharge
slows considerably
or composition of
discharged material
changes
1. Always run engine at full throttle.
2. Replace chipper blade or see your
2. Replace chipper blade or see your
authorized service dealer.
1. Low engine RPM.
2. Chipper blade dull.
2. Chipper blade dull.
Excessive
Vibration
1. Loose parts or damaged impeller.
1. See authorized service dealer.