Troy-Bilt 204 사용자 설명서

Now that you have set up your yard vacuum for 
operation, get acquainted with its controls and features. 
These are described below and illustrated on this page. 
This knowledge will allow you to use your new equip-
ment to its fullest potential. 

Allows twigs and small branches up to 3” in diameter to 
be fed into the impeller for chipping. See Figure 4-1.

This plug is inserted into the chipper chute to push twigs 
and small branches towards the impeller blades without 
endangering your hands.

The nozzle adjustment levers are located on each side 
of the nozzle door. They are used to adjust nozzle door 
for ground clearance that will provide the best perfor-
mance for the operating conditions. See Figure 4-1.

Collects shredded or chipped material fed through the 
chipper chute or vacuumed up through the nozzle.

The drive control is located on the upper handle assem-
bly. Squeezing the drive control against the upper handle 
engages the rear wheels. Release the drive control to 
slow down or stop wheel drive. See Figure 4-1.

The caster locks are located on top of each front caster 
wheel. Refer to the Adjustment Section to position wheel 
locks. See Figure 4-1.

See the separate engine manual for the location and 
function of the controls on the engine.

Caster Lock

Chipper

Chute

Drive Control

Vacuum/ 

Chipper 

Bag

Nozzle Door 

Adjustment 

Lever

† Tamper 

Plug

† If Equipped