Troy-Bilt CSV206 사용자 설명서

7

Collects shredded or chipped material fed through the 
chipper chute or vacuumed up through the nozzle.
See Figure 7.

Allow twigs and small branches up to 3” in diameter to 
be fed into the impeller for chipping. See Figure 7.

This plug is inserted into the chipper chute to push 
twigs and small branches towards the impeller blades 
without endangering your hands.

The caster locks are located on top of each front caster 
wheel. Refer to the Adjustment Section to position 
wheel locks. See Figure 7.

The nozzle adjustment levers are located on each side 
of the nozzle door. They are used to adjust the nozzle 
door for ground clearance that will provide the best 
performance for the operating conditions. See Figure 7.

Yard waste such as leaves and pine needles can be 
vacuumed up through the nozzle for shredding.

The drive clutch control is located on the upper handle 
assembly. Squeezing the drive clutch control against 
the upper handle engages the rear wheels. Release the 
drive clutch control to slow down or stop the wheel 
drive. See Figure 7.

The throttle control lever is located on the engine. It 
controls the engine’s speed and stops the engine. 
Refer to the engine manual for further details.

Refer to the engine manual for the location and function 
of these controls.

•

Move throttle control lever to STOP or OFF 
position.

•

Disconnect spark plug wire from spark plug and 
ground against the engine.

Be familiar with all controls and their proper operation. Know how to stop the machine and 

disengage them quickly.

Tamper Plug