Poulan GTB54A 사용자 설명서
5
3
MOUNTING COVER ASSEMBLY TO
SUPPORT ASSEMBLY (See Fig. 3)
NOTE: For ease of assembly, you may wish to obtain the
as sis tance of another person for mounting coverassembly
to tractor.
1. Position cover assembly on ground behind tractor as
as sis tance of another person for mounting coverassembly
to tractor.
1. Position cover assembly on ground behind tractor as
shown.
2. Lift and rotate cover to align cover brackets with support
assembly tubes.
3. Slide cover assembly down onto the support tubes.
FIG. 3
02532
COVER
ASSEMBLY
ASSEMBLY
SUPPORT
ASSEMBLY
ASSEMBLY
ASSEMBLY
02543
HANG SUPPORT ASSEMBLY ON
REAR DRAWBAR (See Fig. 2)
REAR DRAWBAR (See Fig. 2)
1. Slide fl anges of support assembly into drawbar slots
fi rst, then, pivot backwards inserting pin into drawbar
pin hole.
pin hole.
2. Be sure support assembly is seated properly, then
secure with retainer spring.
2
FIG. 2
INSERT
FLANGES
FIRST INTO
DRAWBAR
SLOTS
FLANGES
FIRST INTO
DRAWBAR
SLOTS
SUPPORT
ASSEMBLY
ASSEMBLY
DRAWBAR SLOTS
RETAINER
SPRING
SPRING
PIN
02051
02
051
INSTALL HIGH LIFT BAGGING BLADES
(See Fig. 1)
(See Fig. 1)
CAUTION: Blades are sharp. Protect
your hands with gloves and/or wrap
blade with heavy cloth.
your hands with gloves and/or wrap
blade with heavy cloth.
NOTE: If you already have high lift bagging blades on your
mower, store the supplied blades in a safe place for future
use. Go on to step 2.
1. Raise mower to highest position to allow access to
mower, store the supplied blades in a safe place for future
use. Go on to step 2.
1. Raise mower to highest position to allow access to
blades.
2. Remove blade bolts by turning counterclockwise.
3. Install bagging blades supplied with stamped "THIS
3. Install bagging blades supplied with stamped "THIS
SIDE UP" facing up towards mower, or, blades stamped
with "GRASS SIDE" facing down towards grass.
with "GRASS SIDE" facing down towards grass.
IMPORTANT: To ensure proper assembly, center hole in blade
must align with star pattern on mandrel assembly.
must align with star pattern on mandrel assembly.
4. Install and tighten blade bolts securely (45-55 Ft. Lbs.
torque).
025
44
HIGH LIFT
BAGGING
BLADE
BAGGING
BLADE
BLADE BOLT
(SPECIAL)
(SPECIAL)
MANDREL
ASSEMBLY
ASSEMBLY
FIG. 1
STAR
PATTERN
PATTERN
1
02
051
DRAWBAR
PIN HOLE
PIN HOLE