Gravely 892031 사용자 설명서
13
5. Replace the belt cover removed in step 1. Keep the
discharge chute for operating the machine without
the blower attached.
the blower attached.
NOTE: If you prefer tool-less belt removal, replace the
belt cover with the hardware provided in this kit. See
Figure 14.
belt cover with the hardware provided in this kit. See
Figure 14.
Connect the Discharge Hose
1. Trim the hose to the required length.
For 52-inch and 60-inch Decks, trim the hose so the
hose does not pull tight when the grass container is
in the dump position and the deck is set to its lowest
cutting height.
hose does not pull tight when the grass container is
in the dump position and the deck is set to its lowest
cutting height.
For 72-inch decks no trimming is required.
2. Connect the hose to the blower assembly and then
to the collector inlet. Secure the hose to the
collector inlet with the hose clamp.
collector inlet with the hose clamp.
3. Adjust the collector inlet angle to remove any sharp
bends or kinking.
4 Washers for
52-inch decks
52-inch decks
2 Washers for 60-
& 72-inch decks
& 72-inch decks
Figure 13
Figure 14
52-Inch Decks
60-Inch Decks
Belt Cover
Belt Cover
72-Inch Decks
Belt Cover
CAUTION: Deflected material may cause injury.
ALWAYS operate mower with bagger cover
closed and secured, blower assembly fastened
securely, or with chute deflector in operating
position.
ALWAYS operate mower with bagger cover
closed and secured, blower assembly fastened
securely, or with chute deflector in operating
position.
Item
Description
Item
Description
Figure 15