Chauvet 64-36VWC 사용자 설명서
LED Par 64-36VW B&C User Manual
8
Rev. 4
Do not use a tool
on the bracket
adjustment knob
Mounting
Bracket
Secondary bracket
(used primarily for
standing position)
Aim the fixture with
the gel frame
release pointing up,
(as shown in this
diagram)
the gel frame
release pointing up,
(as shown in this
diagram)
Mounting
Orientation
The LED Par 64-36VW B/C
may be mounted in any safe position, provided there is adequate
room for ventilation.
Rigging
Be sure that the structure can support the weight of the fixture. Please see the “Technical
Specifications” section of this manual for a detailed weight listing. Mount the fixture securely.
This may be done with a screw, nut and bolt, or a hanging clamp. The hole in each bracket is 13
mm in size. When rigging consider routine maintenance and control panel access. Please see
the following steps for installation.
Specifications” section of this manual for a detailed weight listing. Mount the fixture securely.
This may be done with a screw, nut and bolt, or a hanging clamp. The hole in each bracket is 13
mm in size. When rigging consider routine maintenance and control panel access. Please see
the following steps for installation.
·
Be sure to orient the gel frame release so that it is pointing up. Please see the diagram
below for a visual reference.
below for a visual reference.
·
If the power link out is intended to be used with multiple fixture, take into account the length
of each power cable, and mount the fixtures close enough to one another to accommodate
for this.
of each power cable, and mount the fixtures close enough to one another to accommodate
for this.
·
When aiming the fixtures, you may use the bracket adjustment knob. Loosen the knob,
adjust to the desired angle, and then tighten the knob by turning clockwise. Do not use
tools for this step, as it may cause damage.
adjust to the desired angle, and then tighten the knob by turning clockwise. Do not use
tools for this step, as it may cause damage.
·
There is a secondary portion of the bracket, which may be used primarily for floor standing
positions.
positions.
·
Safety cables must always be used.