Troy-Bilt LS 33 TB 사용자 설명서

The control handle has three positions. See Fig. 5-4.

 — Move the control handle to the FORWARD 

position to move wedge toward the log to split.
NOTE: The control handle will return to the NEUTRAL 

position as soon as the handle is released (FORWARD 

position only).
NEUTRAL — 

Release the control handle or move the lever 

to  the NEUTRAL position to stop the wedge movement.
REVERSE

 — Move the control handle to the REVERSE 

position to return the wedge toward the cylinder. The 

control handle stays in the REVERSE position and returns to 

the NEUTRAL position automatically when fully retracted. 

Do not hold the handle in the REVERSE position when fully 

retracted.
NOTE: The REVERSE position may also be moved back to 

the NEUTRAL position manually, if necessary.

If the control handle on your log 

splitter is not functioning properly, STOP USE 

IMMEDIATELY and contact an authorized service 

dealer.

Do not attempt to service, repair or 

replace control valve. Contact an authorized service 

dealer. 

Do not attempt to adjust or modify the 

control valve or the hydraulic system from its 

original settings or manufacture in any way. 

Start the engine as instructed in the Engine Operator’s 

1. 

manual included with the log splitter.
Place the log against the end plate and only split the wood 

2. 

in the direction of the grain.
To stabilize the log, place your left hand on the side of the 

3. 

log opposite the beam as shown in Fig. 5-1. 

Never place a hand on the ends of the 

log, between the log or end plate and the splitting 

wedge.

Only one operator permitted. Adult 

who loads and stabilizes the log, must be the person 

who operates the control handle.

Move the control handle to the forward position to split the 

4. 

wood.
Remove left hand from the side of the log once wedge just 

5. 

contacts the log. Continue moving control handle forward 

to split the log.
Release the control handle to stop the wedge movement.

6. 

Move the control handle to the reverse position to return 

7. 

the wedge.
To remove partially split wood from wedge, move the 

8. 

control handle to the REVERSE position until the wedge is 

fully retracted to allow split wood portion to contact the 

log dislodger.

Never remove partially split wood from 

the wedge with your hands. Fingers may become 

trapped between the split wood. 

Once removed from the wedge with the log dislodger, split 

9. 

the wood from the opposite end or in another location.