Troy-Bilt LS 33 TB 사용자 설명서

One Log Splitter

• 

One Operator’s Manual

• 

One Engine Operator’s Manual

• 

Do not remove the beam support or 

attempt to remove the machine from the crate until 

after you have completed all assembly steps. 

See Fig 3-1.

Use extreme caution when unpacking 

this machine. It is very heavy and may require 

additional people to assist in uncrating.

NOTE: All references in this manual to the left or right side of the 

log splitter are from the operating position only.

Safety glasses

• 

Two 

• 

9/16-inch wrenches (or adjustable wrenches)

Leather gloves

• 

Wire cutters, tin snips or utility knife

• 

Pry bar and/or claw hammer.

• 

Use a pry bar or claw hammer to loosen and remove the 

1. 

top of the crate.
Use a pry bar or claw hammer to remove the four sides of 

2. 

the crate, beginning with the short sides (or left and right 

side of the log splitter). Set the sides of the crate aside to 

avoid injury.
Remove the large plastic cover, if present, and discard.

3. 

Do NOT remove any supports or cut 

any straps securing the log splitter to the crate at 

this time. Only remove straps and/or supports when 

instructed to do so.

Inspect the bottom of the crate for any protruding staples 

4. 

or wood splinters and remove.
Remove any loose parts included with the log splitter 

5. 

(e.g. operator’s manual, etc.).

For shipping purposes, the tongue tube is secured to the 

logsplitter frame near its center. To reposition it, refer to Fig. 3-2 

and Fig. 3-3 and proceed as follows:

Remove the two three-inch hex screws and flange nuts 

A. 

securing the tongue tube to the logsplitter frame.
Carefully slide the tongue tube toward the front of the 

B. 

machine.