Troy-Bilt LS275 사용자 설명서

9

•

Pull the vertical beam lock out and rotate it down. 
See Figure 7. Pivot beam to the horizontal position. 
The beam will lock automatically in horizontal 
position. 

•

Stand behind the reservoir tank to operate control 
handle and to stabilize the log. See Figure 8B.

1.

Use clean fluid and check fluid level regularly.

2.

Use Dexron III Automatic Transmission Fluid or 

10W AW hydraulic fluid.

3.

Use a filter (clean or replace regularly)

4.

Use a breather cap on fluid reservoir.

5.

Make sure pump is mounted and aligned properly.

6.

Use a flexible “spider” type coupling between 
engine and pump drive shafts.

7.

Keep hoses clear and unblocked.

8.

Bleed air out of hoses before operating.

9.

Flush and clean hydraulic system before restarting 
after servicing.

10. Use “pipe dope” on all hydraulic fittings.
11. Allow time for warm-up before splitting wood.
12. Prime the pump before initial start-up by turning 

over the engine with spark plug disconnected.

13. Split wood along the grain (lengthwise) only.

1.

Use when fluid is below 20° F or above 150° F.

2.

Use a solid engine /pump coupling.

3.

Operate through relief valve for long.

4.

Attempt to adjust unloading or relief valve settings 
without pressure gauges.

5.

Operate with air in hydraulic system.

6.

Use teflon tape on hydraulic fittings.

7.

Attempt to cut wood across the grain.

•

Use control handle to run wedge up and down 
beam 6 to 8 times to circulate the hydraulic fluid, 
which will warm and thin the fluid.

•

Place log splitter on a firm, level surface. 

•

To raise the beam for vertical operation:  Pull out 
the vertical beam lock on the tongue.

•

Pivot beam lock down to release the beam. 

•

Move  the beam to the vertical position. Secure it 
with the beam lock on the reservoir tank assembly. 

•

To lower the beam:  Pull out the horizontal beam 
lock on the reservoir tank.

•

Pivot beam lock down to release the beam. 
Carefully pull back on beam and lower it to the 
horizontal position.The horizontal beam lock will 
lock automatically. See Figure 7.

Always turn fuel valve to OFF position 

before transporting the log splitter.

•

Lower the beam to its horizontal position. Make 
certain the beam is locked securely with the 
horizontal beam lock.

•

Remove spring clip and clevis pin from jack stand. 

•

Support the tongue and pivot the jack stand up 
against the tongue. See Figure 9.

•

Secure with the spring clip and clevis pin previously 
removed. See Figure 9.

•

Attach coupler hitch to a class I or higher 1-7/8” ball 
on a towing vehicle; latch securely.

a. If coupler hitch does not fit on ball: Turn 

adjustment nut one turn counter-clockwise.

b. If coupler hitch is too loose on ball: Turn 

adjustment nut one turn clockwise. 

•

Connect the safety chains to the towing vehicle.

•

Plug in the tail lights to the tail light connector on the 
tow vehicle.

NOTE:  Use caution when backing up. It is
recommended to use a spotter outside the vehicle.

Always use the log splitter in the 

vertical position when splitting heavy logs.

Do not tow faster than 45mph 

and check local, state, and federal 
requirements before towing on any public road.