Snapper 281222BE 사용자 설명서

 

1.  Remove mower drive belt cover.  Refer to 
Section “CHECK MOWER DRIVE BELT”. 
2. Move blade lever up and over to the “ON” 
position. 
3. Place deck cutting height in the 3rd position. 
Measure the belt spacing at idler pulley. The 
distance should measure 1-1/4” but no less than 1”. 
See Figure 4.5. 

 

 

 

4.  If the distance is less than 1”, adjust belt tension. 
5.  Remove hairpin and flat washers from pivot stud.  
See Figure 4.6. 
6. Pull front frame forward until distance between 
belt, with blade lever “ON”, measures 1-1/4”. 
 
 

 

 

 

7. Install required number of snap-in frame spacers 
behind channel pivot until the 1-1/4” distance between 
belt is maintained. See Figure 4.7. 

 

 

 

 

8. Reinstall the required amount of flat washers 
removed in step “5.” and install hairpin. See Figure 
4.6. Retain any remaining spacers for readjustment 
when a new belt is installed. 

 
IMPORTANT:  The SNAPPER Rear Engine Rider 
Models with 28” AND 30” decks are shipped with 
additional spacers specifically designed for the Rear 
Engine Rider.  Should additional spacers be required, 
contact an authorized SNAPPER dealer. Snapper 
Models with 33” decks do not require belt tension 
adjustment.