Snapper 281222BE 사용자 설명서

 

Make the following checks and perform the service 
required before each start-up. 
2.1.1.  Check tires and add or release air as needed 
to bring pressure to 12 psi in front and 12 psi in rear 
tires. 
2.1.2.  Check guards, deflectors and covers to make 
sure all are in place and securely tightened. 
2.1.3.  Check engine oil and add oil as needed to 
bring level up to the FULL mark.  Refer to engine 
owner’s manual for oil specifications. See Figure 2.1.  

 

 
2.1.4.  Adjust seat as needed to most comfortable 
position. Refer to Section “OPERATOR’S SEAT 
ADJUSTMENT”. 
2.1.5.  Check blade control to insure it works freely.  
If blade pedals are depressed, blade lever can be 
moved manually from “ON” to “OFF” to stop 
blade. 
2.1.6.  Check Reverse Lockout Mechanism. With 
blade pedals depressed, shift lever must not go into 
reverse. 
2.1.7.  Clean exterior surfaces of cutting deck and 
engine of any accumulation of dirt, grass, oil, etc.  
Keep engine air intake screen and cooling fins clear at 
all times. 
2.1.8.  Add fuel to tank after pushing the Rear Engine 
Rider outside where fumes can dissipate.  Make sure 
fuel filler cap is tight and vent is open after refueling.  
Refer to engine owner’s manual for fuel specifications.  
See Figure 2.2. 
 
 
 
 

 

 
 

 
2.2  OPERATOR’S SEAT ADJUSTMENT 

2.2.1.  FRONT TO REAR ADJUSTMENT 
1.  With the engine stopped, loosen the two adjusting 
knobs and move seat to desired position. After 
adjustment, tighten knobs securely. If seat does not 
move after loosening knobs, it may be necessary to 
loosen the 5/16” patch lock screws located at the rear 
of the seat using a 1/2 inch wrench. See Figure 2.3.