Snapper RP217019BV 사용자 설명서

 

2.  Remove driven disc spring from driven disc 
assembly. Also remove pin and washer from transfer 
rod, and remove end of transfer rod from hole in 
driven disc assembly. See Figure 4.9. 

 

 

 

 
3. Slide driven disc assembly over to 1/8” from 
outside edge of drive disc. See Figure 4.10.  
4.  Loosen jam nut securing transfer rod to ball joint 
on pivot bracket.  See Figure 4.11.  
5.  Turn rod in or out of ball joint until end of rod aligns 
with hole in driven disc assembly from which rod was 
removed.  NOTE: Do not move pivot bracket. 
6.  Reinstall rod as removed in step 2. Move ground 
speed control to ‘slow’ position, then back to ‘fast’ 
position. Recheck the 1/8” measurement described 
previously. Readjust as needed. Tighten nut when 
finished.  
7. Reinstall driven disc spring to driven disc 
assembly. 

 
 
 
 
 
 
 

 
 
 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

If the rubber is badly chunked or worn it must be 

replaced. Install new Driven Disc as follows: 

1.  Remove pin and washer from transfer rod, and 

remove end of transfer rod from hole in driven disc 

assembly. See Figure 4.9.