Snapper GP215512KWV 사용자 설명서

Section 4 - REPAIR & ADJUSTMENTS

WARNING

DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP
engine and blade. Disconnect spark plug wire and
secure away from spark plug. Engine and
components are HOT. Avoid serious burns, allow
sufficient time for all components to cool.

4.3.4. Replacing Driven Disc Rubber Ring

(Continued From Previous Page)

2. Using needle nose pliers, unhook the drive
spring and slide the driven disc assembly off the
hex shaft. See Figure 4.11.
3.  Remove the five machine screws and plate
which secure the rubber ring to the driven disc
hub. See Figure 4.12.
4.  Install new rubber ring.
5.  Reverse above procedures for reassembly and
installation.

FIGURE 4.11

FIGURE 4.12

4.3.5. Replacing Bearing In Driven Disc
If the driven disc bearing fails, remove the driven
disc assembly and replace bearing as follows:
1. Remove snap ring. See Figure 4.13.

FIGURE 4.13

2.  Slide the hub assembly out of the bearing.
3.  Remove the four screws.
4.  Remove bearing and replace with new bearing.
5.  Reassemble components in reverse order.

SHIM
WASHER

SNAP
RING

THRUST
PLATE

BEARING

REMOVE FOUR
MACHINE SCREWS

DRIVEN DISC
PLATE

DRIVEN
DISC HUB

RUBBER
DISC

MACHINE
SCREWS

DRIVEN DISC HUB

RUBBER
RING

PLATE

DRIVEN DISC
ASSEMBLY