Euro-Pro V1730H 사용자 설명서

1. Before using, please ensure that the cordless sweeper has been initially  

charged for 16-24 hours.
Your  cordless sweeper will only operate properly when the batteries are fully  

charged. Your sweeper will operate for varying lengths of time on a full charge. 
This will depend upon the type of surface being cleaned. (Longer operating time on 
bare floors vs carpets.)

2. Push the On/Off switch to operate the unit. To turn off, press switch again. (Fig. 4)

3. To release the handle to a comfortable position, apply pressure to the top of 

the sweeper head with your foot while pulling back on the handle. (Fig. 5)

"On/Off" switch

Fig. 4

Fig. 5

Any electronic or electrical appliance should not be 
stored in or exposed to areas of high heat or humidity. Do 
not store your cordless sweeper close to stoves, 
radiators, furnaces or in a bathroom or bathing area.

4. To change the speed of the sweeper, press on the speed control button. As you 

press on it, the speed indicator light will change.  If one light lights up, then you 
have the low speed; two lights, medium speed; three lights, high speed.

5. If the brush roll will jam, all the lights will flash and the unit will stop operating. If 

this occurs, please switch the unit off, clear obstruction from brush bar and then 
depress On/Off switch to start the sweeper again.

1. Remove the extension tube handle from the sweeper power head.
2. Turn sweeper power head upside down being careful Not to accidentally turn the 

unit ON.

3. Remove the brush cover. (Fig. 10) (Refer to page 5 for detailed instructions.)
4. Push in on the locking tab of the gear box and lift gear box to remove. (Fig. 11 & 

Fig. 12) 

5. Lift the brush bar end cap up from the slot. (Fig. 13)
6. Pull the brush bar out from the bushing and slip off the belt to remove the 

brush bar. (Fig. 14)

7. Insert the new brush bar by first  inserting the brush bar into the bushing on the 

end opposite the driver belt. (Fig. 14)

8. Slip the belt over the brush bar cap.
9. Insert the brush bar into the slot. (Fig. 13)
10. Insert the gear box tabs into the tab slots and push down until it clicks into place.
11. To replace the squeegee, follow instructions above for removing the gear box and 

slide the squeegee out from left to right. (Fig. 15)

Gear box 

tabs

Locking 

tab

Lift 

Fig. 13

Fig. 14

Fig. 10

Fig. 11

Fig. 12

Fig. 15